• Stable
• Lifetime guarantee
• Made from recycled material
• Open design (allows vegetation, e.g. grass, to grow through)
• Simple installation before or after paving
• Only one component for: Straight lines, inside radii, outside radii, inside corners and outside corners
• Complete radii
• No waste
• Patented Snap and Spike connection system for strong connections – i.e. no extra connectors are required for the SnapEdge paver restraint

1. Excavating the construction site
2. Placing the ballast
3. Compacting and leveling the ballast bed
4. Connect the required SnapEdge elements
5. Cut the rear stabilizers for inside or outside radii or inside or outside corners
6. Attach the SnapEdge paver restraint to the compacted and leveled surface using pikes*
7. Bring in gravel
8. Levelling gravel – e.g. with our screeding rails
9. Lay your slabs or paving stones
10. Backfill the SnapEdge paver restraint with topsoil, gravel, bark mulch, etc.

* In the sidewalk area one spike approx. every 60cm
In areas with traffic or in corners, one spike every 30 cm.
Other procedures/uses are possible, e.g. as lawn edging

1. Excavating the construction site
2. Placing the ballast
3. Compacting and leveling the ballast bed
4. Bring in gravel
5. Levelling gravel – e.g. with our screeding rails
6. Lay your slabs or paving stones
7. Frame the paving surface with SnapEdge paver restraint
8. Connect the required SnapEdge elements
9. Cut the rear stabilizers for inside or outside radii or inside or outside corners
10. Finally, the SnapEdge edge protection is attached using the ground pegs *.

* In the sidewalk area one spike approx. every 60cm
In areas with traffic or in corners, one spike every 30 cm.
Other procedures/uses are possible, e.g. as lawn edging

Take a look at our special introductory offer!